Camshaft Drive Belt Cover - Front Upper - MG MG6 Series 2011 Service Manual

Engine Mechanical-1.8T
4. Working in the sequence shown, progressively tighten
engine sump bolts to 28–32Nm.
5. Tighten bolts securing transmission to sump to
75–90Nm.
6. Position engine mounting lower tie rod bracket to
sump. Fit and tighten bolts to 90–110Nm.
7. Tighten bolt securing engine mounting lower tie rod to
engine mounting lower tie rod bracket to 100 Nm.
8. Clean front exhaust pipe and turbocharger mating faces.
9. Fit new gasket to front pipe and fit front pipe to
turbocharger. Tighten exhaust nuts to 45–55Nm.
10. Fit new oil filter and fill with oil.
Engine Engine Oil Engine Oil and Oil and Oil and Oil Filter Oil
11. Remove stand(s) and lower vehicle.
12. Connect battery earth lead.
Version 2.0
Filter Filter

Camshaft Drive Belt Cover - Front Upper

Remove
1. Disconnect battery earth lead.
2. Loosen lower screw securing drive gear front upper
cover.
3. Remove 5 screws securing drive gear front upper cover
to rear upper cover.
4. Remove drive gear front upper cover and seal.
Refit
1. Clean drive gear front upper cover.
2. Fit seal to upper cover.
3. Fit drive gear front upper cover, ensuring correct
position of seal.
4. Fit screws securing drive gear front upper cover and
tighten to 5Nm.
5. Tighten lower screw securing drive gear front upper
cover to engine to 5Nm.
6. Connect battery earth lead.
Engine
93