MG MG6 Series 2011 Service Manual page 220

Engine
9. Fit RH inner drive shaft to transmission, align support
bracket and tighten bolts to25Nm.
10. Fit LH inner driveshaft to transmission.
11. Lower vehicle.
12. Connect bottom hose elbow and secure the clip.
13. Connect coolant top hose to coolant elbow.
14. Fit bolt securing battery ground cable to body tighten.
15. Secure starter motor solenoid lead to engine harness
with cable tie.
16. Fit multiplug in the fuse box and tighten both bolts to
10 Nm.
17. Connect transmission multiplug connector.
18. Position transmission breather pipe and secure the clip.
19. Fit crankcase breather to throttle body intake hose and
connect hose to wastegate control valve.
20. Remove plugs and connect fuel line to fuel rail.
21. Connect vacuum hose to intake manifold.
22. Connect coolant heater hose to cylinder block and
secure with clip.
23. Connect coolant heater hose to coolant elbow and
secure clip.
24. Connect return hose to coolant reservoir at cylinder
block and secure clip.
25. Fit PASpump assembly and tighten nuts and bolts to
45Nm.
26. Connect PASpressure sensor multiplug.
27. Fit and secure PASreturn hose to reservoir.
28. Fit PASreservoir to RH engine hydramount and tighten
bolts to 7–10 Nm.
29. Position gear selector cable, align bracket to gearbox
and tighten bolts to70–90Nm.
30. Secure selector cable to transmission bracket with clip.
31. Connect gear selector cable to starter inhibitor/position
sensor and tighten nut.
32. Position AC compressor to mounting and secure with
bolts to 22–28Nm.
33. Connect vacuum pipe to throttle body.
34. Fit battery carrier support bracket and tighten bolts
to7–10Nm.
35. Fit battery carrier and tighten bolts to 19–25Nm.
36. Connect battery earth cable and harness clips to
battery carrier bracket.
37. Fit battery carrier bracket.
Battery Battery Battery Carrier Carrier Bracket Carrier Bracket Bracket
38. Fit air cleaner assembly.
Air Cleaner Cleaner
Air Air Cleaner
Version 2.0
Engine Mechanical-1.8 VCT
39. Fit ECM.ECM.
Engine Control Control Module Module (ECM)
Engine Engine Control Module
40. Fit alternator.
Alternator Alternator Alternator
41. Fit starter motor.
Starter Starter Motor Starter Motor Motor
42. Fit front subframe.
Subframe - - - Front Front
Subframe Subframe Front
43. Fill and bleed cooling system.
Coolant Coolant - - - Drain, Coolant Drain, Flush Drain, Flush and Flush
44. Bleed the power steering system.
Power Assisted Power Power Assisted Steering Assisted Steering System Steering
(ECM)
(ECM)
and Refill and Refill Refill
System Bleeding System Bleeding Bleeding
204