Lubrication & Maintenance; Capacities; Fluids - MG MG6 Series 2011 Service Manual

Table of Contents

Advertisement

Lubrication & Maintenance
Lubrication & Maintenance

Capacities

Fluid Capacities
The following capacities are only an approximation of the
amount of fluid required to fill the respective system:
Component/system
Fuel tank
Usable
From dry
Engine-K1.8
Engine oil and filter change
Manual gearbox
Refill
Fill from dry
Automatic gearbox
Refill
Cooling system
MT Brake system fluid (fill
from dry)
AT Brake system fluid (fill
from dry)
Windscreen washer
reservoir
Version 2.0

Fluids

Fuel
Always use the following recommended fluids:
Petrol engines
Use unleaded petrol with a minimum octane rating of 93
Capacity
RON to GB17930 specification.RON Do not use petrol that
contains Methanol.
Antifreeze Solutions
62 L
Use a 50% mix of water and OAT. Antifreeze and Summer
63 L
Coolant or any ethylene glycol based antifreeze (containing no
methanol) with Organic Acid Technology (OAT) corrosion
inhibitors to protect the cooling system.
4.9 L
containingOAT corrosion inhibitors should be used.
Do not top-up or refill cooling system with any other type of
2.0 L
antifreeze. In an emergency, if this type of antifreeze is not
available, top-up the cooling system with clean water only but
2.2 L
be aware of the resultant reduction in frost protection. The
correct antifreeze concentration must be restored as soon as
7.9 L
possible.
7.8 L
The cooling system should be drained, flushed and refilled with
0.8 L
the correct amount of antifreeze solution at the intervals given
on the Service Maintenance Check Sheet.
0.75 L
After filling with antifreeze solution, attach a warning label to a
prominent position on the vehicle stating the type of antifreeze
3.8 L
contained in the cooling system to ensure that the correct type
is used for topping-up.
Antifreeze Concentration
The overall antifreeze concentration should not fall, by volume,
below 50% to ensure that the anticorrosion properties of the
coolant are maintained. Antifreeze concentrations greater
than 60% are not recommended as cooling efficiency will be
impaired.
The following recommended quantities of antifreeze will
provide frost protection to -37℃ - 40℃.
Engine - K1.8
Concentration
Amount of antifreeze
Brake/Clutch Fluid
Use only DOT 4 brake fluid.
PAS Fluid
Use fluid to Dexron III specification.
General Information
Only antifreeze
50%
3.9 litres
29

Advertisement

Table of Contents
loading

Table of Contents