Intermediate Pipe - MG MG6 Series 2011 Service Manual

Engine Manifold & Exhaust System

Intermediate Pipe

Remove
Warning: Exhaust components get extremely hot during
operation. Ensure exhaust components are sufficiently
cooled before handling.
1. Disconnect battery earth lead.
2. Raise the vehicle on a lift.
3. Remove bolts securing brace to body and remove
brace.
4. Remove tailpipe and silencer.
Tail Tail Pipe Tail Pipe and Pipe and and Silencer Silencer Silencer
5. Disconnect post catalyst HO2S multiplug (Turbocharged
models only).
6. Remove 3 nuts securing intermediate pipe to front pipe,
(Turbocharged model shown, VCT similar).
Version 2.0
7. Release 3 rubber mountings securing intermediate pipe
to body.
8. Remove intermediate pipe and collect gasket.
9. Remove HO2S from intermediate pipe, (Turbocharged
models only).
Refit
1. Clean component mating faces. Apply anti-seize
compound to thread of HO2S.
2. Fit HO2S to intermediate pipe and tighten to
45–60Nm.(Turbocharged models only).
3. Clean mating faces of front and intermediate pipes and
fit new gasket.
4. Position intermediate pipe to front pipe, fit rubber
mountings, fit and tighten nuts to 55–75Nm.
5. Connect HO2S multiplug (Turbocharged models only).
6. Fit tailpipe and silencer.
Tail Pipe Pipe and and Silencer Silencer
Tail Tail Pipe and Silencer
7. Fit the brace to the body, and tighten the bolt to
19–28Nm.
8. Lower the vehicle.
9. Connect battery earth lead.
Engine
253