Hinge - Rear Door - Lower; Door - Rear - Align On Hinges - MG MG6 Series 2011 Service Manual

Body Systems

Hinge - Rear Door - Lower

Remove
1. Remove rear door.
Door Assembly Assembly - - - Rear Rear Remove
Door Door Assembly Rear
2. Mark position of lower hinge and remove bolt securing
hinge from outside of 'BC' post.
3. Remove 'BC' post lower trim.
Trim Trim Trim Finisher Finisher - - - 'BC' Finisher 'BC' Post 'BC'
4. Mark hinge position and remove bolt securing hinge
from inside of 'BC' post and remove hinge.
Refit
1. Position lower hinge to 'BC' post.
2. Secure with 2 bolts, align to witness marks and tighten
to 30–36Nm.
3. Fit rear door.
Door Assembly Assembly - - - Rrear Rrear Refit
Door Door Assembly Rrear
4. Align door on hinges.
Door - - - Rear Rear - - - Align Align on on on Hinges
Door Door Rear Align
5. Fit 'BC' post lower trim.
Trim Trim Trim Finisher Finisher - - - 'BC' Finisher 'BC' Post 'BC'
Version 2.0
Remove
Remove
Post - - - Lower Post Lower Lower Remove Remove Remove
Refit
Refit
Hinges Refit Refit
Hinges Refit
Post - - - Lower Post Lower Refit Lower Refit Refit

Door - Rear - Align on Hinges

Adjust
1. Open door.
2. Place wooden block on jack and position jack to
support door lower edge.
3. Loosen 3 bolts securing hinges to door.
4. Loosen 2 Torx bolts securing door latch striker.
5. Use jack to assist with door alignment.
6. Tighten hinge bolts.
7. Remove jack and close door to check for correct
alignment.
8. When alignment is satisfactory, tighten hinge bolts to
30–36Nm.
9. Adjust door latch striker.
Door - - - Rear Rear - - - Adjust Adjust on on on Striker
Door Door Rear Adjust
Doors
Striker
Striker
780