Lh Shaft & Both Joints - MG MG6 Series 2011 Service Manual

Drive Axle
10. Ensure lower ball joint is fully engaged in hub and bolt is
located in ball joint groove.
11. Ensure tapers in track rod end and steering arm are
clean and rubber boot is not damaged.
12. Fit track rod end to steering arm and tighten nut to
28–32Nm.
13. Ensure anti-roll bar and link mating faces are clean.
14. Position link to anti roll bar, fit and tighten nut to
60–70Nm.
15. Fit new drive shaft nut and tighten nut to 350–370Nm.
16. Stake nut to drive shaft.
17. Fit front wheel arch liner.
Liner - - - front front wheel wheel arch
Liner Liner front wheel
18. Lower the vehicle.
Version 2.0
arch - - - front front
arch front
LH Shaft & Both Joints
Remove
1. Raise the vehicle on a lift.
2. Remove front wheel arch liner.
Liner Liner Liner - - - front front wheel front wheel arch wheel
3. Prise locking device from nut. With an assistant pressing
brake pedal, remove and discard drive shaft nut.
4. Remove nut from track rod end.
5. Fit an M10 nut to ball pin, flush with end of pin.
6. Break taper joint usingT38008 and release end from
track rod.
7. Remove nut from ball pin.
8. Remove nut securing link to anti roll bar and release
link.
9. Remove nut and bolt securing hub to lower arm.
10. UsingT32011 release lower arm ball joint.
Driveline/Axle
arch - - - front arch front front
647