MG MG6 Series 2011 Service Manual page 953

Displays and Gages
warning until the seat belt are buckled correctly, or until 90
seconds has expired.
SRS Warning Light
The warning light illuminates red. If the warning light is still
on after self-testing, this means the SRS control unit has failed.
When the engine start, the message centre will display "SRS
failure, please repair!'. Because this is an important warning
function, when the ignition is in IGN position, the instrument
pack will monitor the warning light continuously. If the warning
light fails, the message centre will display 'SRS warning light
failure', after this information is displayed for 3 seconds, the
warning symbol will be permanently displayed.
Main Beam Warning Light
The warning light illuminates blue. When the main beams are
switched on, theBCM will send a signal to the instrument pack
via the BUS.
Cruise Control Warning Light
The warning light can illuminate either yellow or green. When
the ignition is switched on, initially the light illuminates green,
then after a short period it illuminates yellow. If the warning
light is green after self-testing, cruise control is in stand by, if
the warning light is yellow, cruise control is active.
Due to this warning is just a function indicator when driving
the car, so avoid to disturbing the driver, when the turn on the
vehicle light, the illumination can be adjusted.
The message centre will
stand-by','Cruise control setting XX km/h' and 'Cruise control
failure!'to represent the different cruise function status.
When first time active or set Cruise control, the system will
use the current vehicle speed as target, the warning light
color is yellow, the message centre will display 'Cruise control
setting XXkm/h', display time is 3 seconds, and XX is target
vehicle speed. When the vehicle meet the target speed, the
information will display again for 3 second. The target speed
can use the cruise knob to change. When the current target
vehicle speed change, the active information will be displayed
again, and update the target speed. When the driver use
accelerator pedal or brake pedal to change the speed and
out of range, the cruise control system will stand-by, the
warning light color is green. If the driver press the cruise
setting button again, the car will use the last target speed as
new target speed to restart cruise control.
During non stand-by cruise control, ifEMS detected the cruise
control failure, the cruise control warning light (yellow) will
flash three times. The message centre will display 'Cruise
control failure!'
Front Fog Lamp Warning Light
The warning light illuminates green when the front fog lamps
are on. The front fog lamps will only operate when the ignition
Version 2.0
display: 'Cruise control
Information and Entertainment
and the sidelights are on. The relevant information will be
displayed on message centre.
Rear Fog Lamp Warning Light
The warning light illuminates yellow when the rear fog lamps
are on. The rear fog lamps will only operate when the ignition,
the sidelights and the front fog lamps are on. The relevant
information will be displayed on message centre.
Side Lamps On Warning Light
The warning light illuminates green. When the sidelights are on
the illumination dims to night-time mode and the panel dimmer
thumbwheel becomes active.
Low Oil Pressure Warning Light
When low oil pressure is detected, the red warning light will
illuminate, the message centre will display relevant warning
information and an audible warning will sound to alert the
driver. This failure can cause engine damage, so repairs should
be carried out immediately.
Electronic Steering Column Lock (
This warning light is used to indicate faults in the ESCL. The
indicator illuminates as a system check when the ignition is
switched on and should extinguish after about 5 seconds. If
there is a fault with the ESCL, the warning light will remain
illuminated and the message Steering Lock Fault will appear in
the message centre.
Passenger Airbag Off
This warning light is used to indicate that the passenger airbag
has been disabled. The indicator illuminates as a system check
when the ignition is switched on and should extinguish after
about 5 seconds. If the passenger airbag has been disabled,
the light will remain illuminated until the airbag is enabled, and
the message Passenger Airbag Off will appear in the message
centre. Once the passenger airbag has been enabled, the
light will extinguish and the message Passenger Airbag On will
appear in the display. If lamp failure, the message Passenger
Airbag lamp Fail will be displayed.
Alarm Status
The indicator provides information about the status of the
alarm system when ignition is off and the alarm is set, see
'Anti-theft alarm indicator'.
)
ESCL
937