Clutch Release Bearing; Clutch Master Cylinder (A) - MG MG6 Series 2011 Service Manual

Transmission

Clutch Release Bearing

Remove
1. Remove transmission assembly.
Manual Transmission Transmission Assembly–Remove
Manual Manual Transmission
2. Hold clutch release arm and remove clutch release
bearing from guide sleeve.
Refit
1. Clean component mating faces.
2. Lubricate bearing running surface with molybdenum
disulphide grease.
3. Fit clutch release bearing to guide sleeve.
4. Fit manual transmission.
Manual Transmission Manual Manual Transmission Transmission Assembly–Refit
Version 2.0
Assembly–Remove
Assembly–Remove
Assembly–Refit Assembly–Refit

Clutch Master Cylinder (A)

Remove
1. Remove battery carrier.
Battery Carrier Carrier Bracket–Remove Bracket–Remove
Battery Battery Carrier Bracket–Remove
2. UseT22002 to disconnect clutch slave cylinder pipe
connection.
3. Remove steering column lower panel assembly and the
panel heater closure.
Panel Assembly–Fascia Panel Panel Assembly–Fascia Closing Assembly–Fascia
Driver–Remove
Driver–Remove Driver–Remove
Panel–Heater Closure–Remove Closure–Remove
Panel–Heater Panel–Heater Closure–Remove
4. Release clip and remove clevis pin securing master
cylinder push-rod to clutch pedal.
5. Remove 2 bolts securing clutch master cylinder to
pedal bracket.
6. Release clutch pipe grommets.
7. Remove master cylinder and fluid pipe, manoeuvring
clutch pipe through grommet holes.
8. Remove grommet from fluid pipe.
Refit
1. Fit grommet from fluid pipe.
2. Manoeuvre fluid pipe through grommet holes and
secure grommets in holes.
3. Position master cylinder to pedal bracket, fit and tighten
Clutch
Closing Panel– Closing Panel– Panel–
442