Handle - Outside - Rear Door; Door Assembly - Rear - MG MG6 Series 2011 Service Manual

Body Systems

Handle - Outside - Rear Door

Remove
1. Remove grommet for access to screw securing outside
handle capping to inner door handle.
2. Loosen screw securing outside door capping lock to
inner door handle (Do not remove screw it is captive).
3. Remove outside handle capping.
4. Move handle backwards then rotate rear of handle
outwards and remove by releasing from front tags.
Refit
1. Using a piece of string loop round door inner release
lever, pull outwards to engage behind outside handle
release lever.
2. Fit door handle to front tags and rotate to locate into
rear door aperture.
Caution: Ensure door handle gaskets are fitted correctly.
3. Position and fit outside capping to door handle
assembly, tighten screw to 2–2.5Nm.
4. Refit grommet and ensure seal properly.
Version 2.0

Door Assembly - Rear

Remove
1. Disconnect battery earth lead.
2. Open front door for access. Release harness sleeve
from 'BC' post, disconnect multiplug.
3. Open rear door.
4. Remove upper hinge cap nut.
5. Remove centre bolt securing lower hinge to door.
Doors
778