Pipe - Steering Rack To Oil Cooler - MG MG6 Series 2011 Service Manual

Front Wheel Steering
Caution: To prevent damage to components, use two
spanners when loosening or tightening unions.
Caution: Always fit plugs to open connections to prevent
contamination.
8. Remove feed pipe from engine compartment.
Refit
1. Clean pipe ends and mating faces.
2. Position feed pipe in engine compartment.
3. Using new sealing washers, position pipe to pump,
remove plug, fit union and tighten to 38–42Nm
Caution: To prevent damage to components, use two
spanners when loosening or tightening unions.
4. Using new sealing washers, position pipe to steering
rack, remove plug, fit union and tighten to 26–30Nm
Caution: To prevent damage to components, use two
spanners when loosening or tightening unions.
5. Fit undertray.
Understray Understray Refit Understray Refit Refit
6. Remove container.
7. Connect PAS pressure sensor multiplug.
8. Connect battery earth lead.
9. Bleed power steering system.
Power Power Assisted Power Assisted Steering Assisted Steering System Steering
Version 2.0
System Bleeding. System Bleeding. Bleeding.

Pipe - Steering Rack To Oil Cooler

Remove
1. Disconnect battery earth lead.
2. Raise vehicle on lift.
3. Remove undertray.
Undertray Remove Remove
Undertray Undertray Remove
4. Position container to collect spillage.
5. Release clip securing return pipe to oil cooler and
disconnect pipe from oil cooler.
Caution: Always fit plugs to open connections to prevent
contamination.
6. Remove 2 screws securing pipe to subframe.
7. Remove union securing pipe to steering rack, remove
and discard washers.
Caution: Always fit plugs to open connections to prevent
contamination.
8. Remove pipe from engine compartment.
Refit
1. Clean pipe ends and mating faces.
2. Position pipe in engine compartment.
3. Remove plug from steering rack.
4. Using new sealing washers, position pipe to steering
rack, remove plug, fit union and tighten to 26–30Nm
Steering System
531