Crankshaft Pulley - MG MG6 Series 2011 Service Manual

Engine Mechanical-1.8T

Crankshaft Pulley

Remove
1. Disconnect battery earth lead.
2. Remove starter motor.
Starter Starter Starter motor motor motor
3. Raise front of vehicle.
Warning: Do not work on or under a vehicle supported
only by a jack. Always support the vehicle on safety
stands.
4. Remove RH front wheel.
5. Remove ancillary drive belt.
Drive Drive belt Drive belt belt
6. Fit flywheel locking tool T10036 automatic
transmission)T10037manual transmission) to flywheel
housing and secure with bolts.
7. Remove bolt securing pulley to crankshaft and collect
washer.
8. Remove crankshaft pulley.
Refit
1. Clean crankshaft pulley and mating face.
2. Fit crankshaft pulley and ensure indent on pulley locates
over lug on crankshaft timing gear.
3. Fit washer and tighten bolt securing crankshaft pulley
Version 2.0
to 200–210Nm
4. Remove bolts and remove flyingwheel locking tool.
5. Fit ancillary drive belt.
Drive Drive Drive Belt Belt Belt
6. Fit wheel and tighten bolts to 115–130Nm.
7. Remove stand(s) and lower vehicle.
8. Fit starter motor.
Starter Motor Motor
Starter Starter Motor
9. Connect battery earth lead.
Engine
95