Clutch Slave Cylinder (A) - MG MG6 Series 2011 Service Manual

Transmission
Refit
1. Fit grommet from fluid pipe.
2. Manoeuvre fluid pipe through grommet holes and
secure grommets in holes.
3. Position master cylinder to pedal bracket, fit and tighten
bolts to 7–10Nm.
4. Position master cylinder push-rod to clutch pedal, fit
clevis pin and secure with clip.
5. Fit steering column lower panel assembly and the panel
heater closure.
Panel Assembly–Fascia Assembly–Fascia Closing
Panel Panel Assembly–Fascia
Driver–Refit
Driver–Refit Driver–Refit
Panel–Heater Closure–Refit Closure–Refit
Panel–Heater Panel–Heater Closure–Refit
6. Connect master cylinder pipe connection until hear
'click' sound and then rotate the connection 180°,
which ensure installation is correct.
7. Connect master cylinder low pressure hose to
reservoir and secure with clip.
8. Top up fluid level in brake reservoir to 'MAX' mark.
9. Bleed the clutch system.
Clutch Clutch System Clutch System Bleeding System Bleeding Bleeding
10. Fit battery carrier.
Battery Battery Battery Carrier Carrier Bracket–Refit Carrier Bracket–Refit Bracket–Refit
Version 2.0
Closing Panel– Panel–
Closing Panel–

Clutch Slave Cylinder (A)

Remove
1. Remove battery carrier.
Battery Carrier Carrier Bracket–Remove Bracket–Remove
Battery Battery Carrier Bracket–Remove
2. UseT22002 to disconnect clutch slave cylinder pipe
connection.
3. Remove undertray.
Undertray–Remove
Undertray–Remove Undertray–Remove
4. Remove clip securing slave cylinder to bracket and
release slave cylinder.
5. Remove clutch slave cylinder.
Refit
1. Connect clutch slave cylinder pipe connection.
2. Position slave cylinder push rod against clutch release
arm.
3. Fit slave cylinder to bracket and secure with clip.
4. Fit undertray.
Undertray–Refit
Undertray–Refit Undertray–Refit
Clutch
444