Service Procedures; Arm - Wiper - Each; Motor And Linkage - Wiper - MG MG6 Series 2011 Service Manual

Wipers and Washer

Service Procedures

Arm - Wiper - Each

Remove
1. Open bonnet.
2. Remove windscreen wiper arm fixing cover.
3. Remove nut securing windscreen wiper arm to linkage.
4. Remove windscreen wiper arm from linkage.
Refit
1. Fit and align windscreen wiper arm to linkage spindle.
2. Fit nut to linkage spindle and tighten to30Nm.
3. Fit windscreen wiper fixing cover. 4 Close
4. Close bonnet.
Version 2.0

Motor and Linkage - Wiper

Remove
1. Disconnect battery earth lead.
2. Remove wiper arm.
3. Remove air intake plenum.
Plenum Plenum Plenum - - - air air air intake intake intake
4. Remove bolts securing motor and linkage to body.
5. Disconnect multiplug from windscreen wiper motor
and remove motor and linkage.
Refit
1. Connect multiplug to windscreen wiper motor.
2. Fit motor and linkage and tighten bolts to7–10Nm.
3. Fit air intake plenum.
Plenum Plenum Plenum - - - air air intake air intake intake
4. Fit wiper arm.
5. Connect battery earth lead.
Exterior Fitting
735