Table of Contents
Advertisement
Introduction
1.3
Main technical characteristics
1.3.1 Trolley
The mechanic structure of the trolley is made of completely non-magnetic materials.
The pedestal base is made of a shockproof ABS and polyester coated. This ensures
an excellent impact resistance thanks to its flexibility and excellent abrasion
resistance.
Its dimensions and weight are very reduced and allow its installation also in small
rooms or small working areas or combined with pendant lifting systems.
The work-shelf is mono-bloc, made of a unit PUR mould. The shelf also includes the
housing for the valves group and the manual ventilation controls. The shelf is very
wide and the large handle below the perimeter allows to hold and easily move the
unit.
On the left side a steel rod at full height is provided for fixing the patient monitor and
other accessories like for example the supporting arm for patient circuit, infusion
pumps, etc.
The lateral uprights are provided with a vertical guide for fixing the accessories or
lateral devices, e.g. the pendant lifting system, lateral lectern or PC support for
medical record writing.
On the back side are the medical gas intakes, which are positioned in a rational and
easily visible way. The intake for main supply system and pressure reducer-cylinder
are also provided, with a non return valve and automatic change. In case of main gas
failure just open the cylinder and the gas will be immediately available for use without
additional manoeuvres.
1.3.2 Valves group
Completely renewed and performing, it presents the following definite advantages.
•
Extraction from above and perfect integration with the work-shelf.
•
Automatic connections with double seal gaskets against accidental leaks.
•
Mono-bloc, fully sterilizable in autoclave
•
Automatic flow sensor and oxygen sensors calibration procedure activated by
operator
•
The access to flow sensor and O 2 sensor is simple and immediate.
1-2
MORPHEUS MRI
Advertisement
Table of Contents
