Table of Contents
Advertisement
Breathing
system
Flow sensor Single patient use type at differential
Other
accessories
Electrical
connections
User's Manual, DU3310103-MRI / rev.3 - 02.05.2019
Dismantle and clean, then sterilize in an
autoclave, disinfect with steam or
chemically.
pressure
WARNING. Risk of device failure.
Replace the sensor according to the procedures and local
ref. directives and in function of use of filters on patient
circuit.
Carefully follow the manufacturer's
instructions.
On the aim to guarantee patient and
operator safety it is necessary to keep the
power supply cable in perfect conditions.
Maintenance
Before using again,
eliminate any humidity
inside the components
by means of
compressed air.
It is possible to sterilize
with gamma rays or with
ethylene oxide (ETO), at
first use.
Refer to the
accompanying
documentation.
Perform daily checking's
of cable condition; any
damage, also a
minimum damage, must
be promptly eliminated,
eventually replacing the
whole cable.
10-9
Advertisement
Table of Contents
