Table of Contents
Advertisement
Appendix
Automatic compensation
of atmospheric pressure
on measured pressure
Respiratory parameters
default setting
Flow generation
Gas feeding
Autotest
Ventilation modalities
Breathing rate
I:E Ratio
Inspiratory time
Tidal Volume
Minute Volume
PEEP
Inspiratory Flow
Oximeter
High pressure limit
Bronchomanometer
Flow trigger
Pressure trigger
Safety
Flow sensor
Alarms
Measured parameters
11-6
Present (max. 5000 mt)
Present (newborn, children, adult)
Electronic system
Medical compressed air or Oxygen with pressure included between 280 kPa and
600 kPa (2,8 – 6 bar)
Primary test: at anaesthesia unit's start-up, a control test of medical gas supply,
sensors operation, back-up battery, oxygen cell, integrity of the alarm audible
indicator, led on CPU board. This test takes around 15 seconds.
Subtest: this subtest permits to verify the dead space and losses or to perform
the oxygen cell calibration.
MANUAL, VC-VAC, PCV-APCV
From 5 to 90 bpm (step 1 bpm)
1:4 ÷ 4:1
From 0.2 to 5 sec.
From 50 to 1500 ml
From 1 ÷ 30 liters
OFF, 3 ÷ 30 cmH 2 O
From 1 ÷ 80 L/min.
Minimum resolution 1% / Automatic calibration procedure
From 10 to 80 cmH 2 O
Electronic: from -10 ÷ 80 cmH 2 O
From OFF, 1 to 15 L/min (step 1 L/min)
From OFF, -1 to -9 cmH 2 O under the PEEP level
Electronic and mechanical limit of airways pressure / Self-diagnosis system
Pressure relief single patient sensor
Fan Failure, Air Failure, High / Low Airways Pressure, Low O 2 concentration, O 2
cell into operation or not present, Apnoea, Expired Tidal Volume, Power Failure,
Low Battery.
PAW, FiO 2 , VM, Tinsp, RATE, Vte
MORPHEUS MRI
Advertisement
Table of Contents
