Cq 1 1 The Light Copy (Partial) - Xerox 3050 Service Manual

CQ 11
The Light Copy (Overall)
(Continued)
Probable Cause Corrective Action
i. Media is damp.
ia. Cut sheet media:
Make a copy, using a sheet of media from
a new pack of media.
If the problem i s corrected, ensure that the
media
i s
being stored correctly.
ib.
Roll media:
Remove and discard the first
3
to
6
feet
(1
t o
2
metres) of media from the roll. Make
a
copy on the new media.
If the problem is corrected, ensure that the
roll media
i s
being stored correctly.
Refer to Section
2
and ensure that the
Media Heater is working.
7.
Replace the Developer Material (REP
9.7).
3. Go to the CQ 25 Developer Bias RAP.
9.
Check that the Developer Drive coupling i s
i n position and the Augers are turning.
10. Some chemicals can cause damage or
contamination of
the drum.
Wash (General Procedures) or replace the
drum
(REP 9.3),
and perform the
Electrostatic Series (ADJ 9.2). If the
problem still exists, notify technical
support.
Developer material has more than 40K
feet (1 2.2K meters) of copies on
it.
The developer bias is out of specification.
Developer mixing Augers are not turning.
There are airborne chemicals.
(Continued)
8/94
CQ 11 The Light Ldpy (Overall)
3-42 3050