Rep 9.3A; Rep; Photoreceptor Drum; Cleaner Blade - Xerox 3050 Service Manual

(continued)
Replace the seal i f it
b
damaged.
3. Clean the Photoreceptor Seal (PL 9.5,
Item 12). Move the Seal towards the
photoreceptor drum, i n order to provide
a seal between the photoreceptor drum
and the auger extrusion.
Reform the seal as required so that, the
Seal is pointing towards the Charge
Corotron.
Removal o f the Charge Corotron
@
,Erase
Lamp b
required i n order to
avoid contamina tlng the Corotron,
with steara te dust.
4.
Remove the Charge Corotron
/
Erase
Lamp.
I f an encesdve amount o f stearate
is
applied to the cleaning blade, the
stearate may contaminate the
Transfer1 Detack Corotron.
A
contaminated Corotron can cause a
copy quality probIem. Do not apply
an excessive amount o f stearate to the
cleaner blade,
5.
Apply a light coating of stearate dust to
the Cleaner Blade.
6. Reinstall the Charge Corotron
/
Erase
Lamp.
7.
Install the Photoreceptor Drum Assembly
8.
(Figure
4):
Remove the stearate from the
in the Xerographic Module (REP 9.2).
Photoreceptor Drum..
9. Install the Xerographic Module (REP 9.1).
STEP
88: Compress the solenoid
plunger
M ,
that, the dwner blade
10.
Perform the Cleaner Blade Solenoid
comes in contact with the Adjustment (ADJ 9.1).
Photoreceptor Drum.
11. Perform the Electrostatics Series (ADJ
9.2).
ROTATE UNTIL DRUM tS
FREE O F ALL STEARATE
COMPRESS SOLENOID
D
PLUNGER FULLY
Figure
4.
Removal of the Stearate from the Photoreceptor
REP
9 . 3
A