Xerox 3050 Service Manual page 512

(Continued)
A
WARNING
Wear protective gloves when handling the
parts with fuser oil on them. Use caution and
do not allow the fuser oil to contact your
eyes. Fuser oil can cause severe eye irritation.
Wash hands after handling any components
that are covered wlth fuser oil.
WARNING
Use entreme caution when working in the
fuser are6 and do not touch any heated
components. The fuser roll WlLL be
hot.
A
WARNING
Ensure that the area where comaonents with
fuser oil is present is protected by a drop
cloth. Clean any fuser oil spllls wlth warm
water and soap to avoid the posslbllty of
bodily injury due to falls.
7.
Connect the Power Cord and enter
diagnostics.
8. Place a magnet on the Copy Feed Shelf
Interlock Switch.
9.
Enter the code
109 21 41
and wait for the
Fuser roll to warm to run temperature.
I f to921 41 times out while performing
the oiling process, reenter the code
[O!l
2 1 41 and continue.
10. Apply part of an 8cc tube of fuser oil
(93E0081l) to a folded soft cloth.
11. Wipe the fuser oil soaked cloth
evenly across the entire surface of
the Fuser Roli.
12. Repeat Steps 10 and 1 1 until the
entire contents of the tube of oil is
used.
Q Dry areas appear as dull spots, as
opposed to oiled areas that
appear as glossy areas.
13. Inspect for dry and/or contaminated
areas on the Fuser Roll. If dry or
contaminated areas are found, wipe
the pad with oil back and forth across
the area while applying pressure.
14.
Press the Stop button two times.
15.
Wipe the Fabric Guide with the same
cloth to remove any excess oil and
debris that may be present.
16. Clean the Fabric Guide with a clean
dry pad.
17.
Reinstall the following:
a. Oil
Dispense Assembly (REP 10.7)
b. Stripper Finger Assembly
(REP
10.6)
18. Remove the magnet from the Copy
Feed Shelf Interlock Switch and raise
the Copy Feed Shelf.
21.
Exit
diagnostics and select a quantity of 6
to make 6 copies of the blank side of the
test pattern (82E5980) (all white) to remove
any excess oil from the Fuser Roll surface.
Use extreme caution when working in the
fuser area and do not touch any heated
components. The Stripper Finger Assembly
WlLL be hot.
22. Use a thick soft clean cloth to wipe any
excess Fuser
Oil
from the ends of the Fuser
I
Roli and the Fabric Guide.
20. Perform the Fuser Temperature
Adjustment (AD1 10.1).
REP 10.1 1