Xerox 3050 Service Manual page 304

Media Handling Problems
(Continued)
Copier Check
6. Check, clean or replace the following
component (continued):
d. Fabric Guide.
e. Fuser roll.
f. Fuser Pressure Plates.
g. Media Transport Module is not latched
against the pins on the Xerographic
Module.
h. Fuser Stripper Fingers
i. Excessive oil
7. After completing the previous checks, run
several copies with dry Xerox media in
order to verify that the problem
is
fixed,
then perform the Final Actions.
Corrective Action
Replace the Fabric Guide (REP 8.9).
Replace the Fuser Roll (REP 10.2) i f it is
glazed or contaminated.
Check that the plate is positioned
correctly and is not bent or damaged.
(PL 10.3).
Ensure that the media transport module
is against the pins. Check the latching
bars and transport latching cover for
damage.
Ensure that the fuser stripper fingers
(REP 10.8) are not damaged.
Check the oil pads (REP 10.9); replace the
wick (REP 10.1 1)
.
(WI Tag1 MOD 18): Check that the
Dispense Roll Springs have not been
removed from inside the Roll.
31 93
Media Handling Problems
3-20 3050