Cq 11 The Light Copy (Partial) - Xerox 2510 Service Manual

CQ
11
The Light Copy (Partial) Probable Cause Corrective Action
Copier is not level.
1.
Developer module or xerographic 2.
module is not fully seated against the
stops.
I
The light can enter the copier through 3.
an opening in the covers.
Fans not functioning or ozone filter 4.
contaminated or blocked.
The magnet and lens are not installed
5.
correctly against the frame of the
copier.
The lens stileld i s separated from the 6.
lens assembly
I
Bowed, damaged, or contaminated 7.
corotrons.
Photoreceptor not seated correctly on 8.
the Drum Shaft arbors.
(2510 Only): Cracked or warped Air 9.
Manifold
Level the copier. Refer t o the Installation Procedure
located in Section 6.
Ensure that the developer module and xerographic
module are installed and secured correctly. Ensure that
the Latch Springs are not damaged.
Ensure that the covers are not damaged and that they
are seated correctly. Allow the photoreceptor drum to
rest before trying t o make copies.
Go t o the 1.3 Copier cooling fan RAP in Section 2. Also
replace the ozone filters (PL 9.3).
Check installation of components and i f incorrect
reinstall correctly.
Replace the lens or Install the Light Leak Repair Kit (PL
6.1).
Replace the corotron (PL 8.6, PL 9.2)
Reposition the Photoreceptor Drum on the arbors.
Replace the Air Manifold (PL 9.3).
(2515 Only): Air Manifold blocked by 10. Replacetheseal (PL9.2).
the U-shaped seal in the Cleaner
Assembly.
Photoreceptor damage (crystallization). 1 1. Replace the Photoreceptor (PL 9.1 ).
I
12. (2510 Only): Developer Mixing Auger 12. Replace or rebuild the Developer Housing
(
PL 9.4 ).
not functioning correctly.
I
13. Developer Magnetic Roll surface is 13. (2510 Only): Rebuild the Developer Housing (PL9.4).
worn.
(2515 Only): Replace the Developer Housing (PL 9.5).
(Continued)
8/96
251
5 3-57
C Q 11 The Light Copy (Partial)