Xerox 3050 Service Manual page 22

STATUS
CODE
CAUSE CLEARANCE
GO TO RAP IN
SECTION 2
During Automatic Roll switching, media from Roll 2
is not detected
at
the Roll
1
position sensor, while
trying to feed the media forward to the registration
position.
During Automatic Roll switching, media from Roll 3
is not detected at the Roll 1 position sensor, while
trying to feed the media forward to the registration
position.
This is a Firmware problem.
Refer to the display on the control panel
and follow the clearance procedure.
C2.07 Media Feed
RAP
Refer to the display on the control panel
and follow the clearance procedure.
Press power off
(0)
then power on
(1). Call
Hotline if problem persists.
C3.07 Media Feed
RAP
None
During automatic roll switching the empty roll
failed to rewind completely. The Roll X Position
sensor remains covered after the roll stops
rewinding.
Refer to the display on the control panel
and follow the clearance procedure.
C1 .O1 Media Feed
RAP
C2.01 Media Feed
RAP
C3.01 Media Feed
RAP
The new roll selected during automatic roll
switching failed to feed to the cut position. The
Roll X Position Sensor did not actuate.
Refer to the display on the control panel
and follow the clearance procedure.
C1 .O1 Media Feed
RAP
C2.01 Media Feed
RAP
C3.01 Media Feed
RAP
The media stops moving after entering the image
transfer area.
This is the primary out of media condition.
Refer to the display on the control panel
and follow the clearance procedure.
During Automatic Roll Switching media from Roll 3
is not detected at the Roll 2 Position Sensor, while
trying to feed forward to the registration position.
Refer to the display on the control panel
and follow the clearance procedure.
NOTE 1 : Substitute either 1,2, or 3 for X depending on which status code is displayed.
C1.05 Media Feed
RAP
C2.05 Media Feed
RAP
C3.05 Media Feed
RAP
C3.06 Media Feed
RAP
3/93
Status Code Entry Chart
1-8 3050