Xerox 3050 Service Manual page 534

(Continued)
4. Exit the diagnostic mode.
Q
The Control Point and the Sensor
Reading should the same. The Sensor
10.Repeat the Check. Adjust only
2
times if
Reading may vary
f .2
volts. necessary. If the image density remains out of
specification after the second adjustment, go
-
8. (Figure 2): Verify that the toner sensor
t o CQ
11
Light Copy RAP.
5. Run 5 blank copies t o add the toner
voltage has been decreased.
required by the lower toner sensor voltage.
9. Exit the diagnostic mode.
6. Enter the diagnostic mode.
There will be a time delay between the time
the code [0921-41 is entered and the time the
fuser drive motor starts t o turn. The fuser
drive motor will not start until the fuser is at
the correct temperature.
7.
Enter the code
[0921-41.
f
.
A
09
21 4
VERIFY THAT THE
VOLTAGES HAVE
CHANGED
Figure 2. Verify the Toner Sensor Voltage
(Continued)
ADJ 9.3