Xerox 3050 Service Manual page 23

STATUS
CODE
CAUSE
CLEARANCE
GO TO
RAP IN
SECTION
2
During Automatic Roll switching, media from Roll 2 is not
detected
a t
the Roll
2
position sensor, while trying to feed
the media forward to the registration position.
During Automatic Roll switching, media from Roll
3 is
not
detected at the Roll
2
position sensor, while trying to feed
the media forward to the registration position.
This is a Firmware problem.
-
-
- -- -
- - . -
- - -
The cutter is unable to move from the home position
when media
is
feeding from the registration position.
Cutter is unable to rotate to cut the copy media.
The cutter is not able to return to the home position when
feeding the media from the registration position.
-- -- -
The roll fails to rewind completely to the park position
from the cutting position. The Roll X Position Sensor
remains covered after roll stops rewinding.
The Roll
X
Position Sensor i s deactuated When roll rewind
is attempted cut position to the park position.
Note 1
- -
This is a Firmware problem.
Refer to the display on the control panel
and follow the clearance procedure.
C2.07 Media Feed
RAP
Refer to the display on the control panel
and follow the clearance procedure.
C3.06
Media Feed
RAP
Press power off
(0)
then power on
(1).
Call
Hotline if problem persists.
None
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
LL.30 Cutter Fault
Rap
LL.30 Cutter Fault
Rap
Refer to the display on the control panel
and follow the clearance procedure.
C1.O1
and
C1.05
Media Feed R A P S
C2.01
and
C2.05
Media Feed RAPS
C3.01 and C3.05
Media Feed R A P S
Refer to the display on the control panel
and follow the clearance procedure.
C1.01 Media Feed
RAP
C2.01 Media Feed
RAP
C3.01 Media Feed
RAP
Press power off (0) then power on (1). Call
Hotline if problem persists.
None
NOTE 1 :
Substitute either 1,2, or3 forX depending on which Status Code is displayed.
31 93
3050 1-9
Status
Code Entry Chart