Xerox 3050 Service Manual page 20

STATUS
CODE
C2.07
C3.07
C1 .O9
C2.09
C3.09
C1
.I 1
C2.11
C3.11
C1.12
C2.12
C3.12
C1.15
C2.15
C3.15
C3.16
CAUSE
CLEARANCE
GO TO RAP I N
SECTION 2
Roll 2 media is not detected at the Roll
1
Position Sensor.
Roll 3 media is not detected at the Roll 1
Position Sensor.
-
--
--
This i s a Firmware problem.
Motion of the Roll
X
was not sensed while Roll
X
was trying to feed the media from the park
position to the cut position. Also, the roll did
not completely rewind.
Note 1
Roll X was trying to feed media forward from
the park position to the cut position. The Roll
X
Position sensor never actuated. The roll was
rewound beyond the park position.
Note 1
The media has passed the Roll
X
Position
Sensor, but stops before reaching the cut
position. Possibly caused by an out of Media
condition.
Note
1
- - -
-
Roll
3
media i s not detected at the roll
2
Position Sensor, while trying to feed media to
the cut position.
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
Press power off (0) then power on (1). Call
Hotline If problem persists.
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
C2.07 Media Feed
RAP
C3.07 Media Feed RAP
None
C1 .O5
and
C l .O1
Media Feed
RAP
C2.05 and C2.01 Media Feed
RAP
C3.05 and C2.01 Media Feed
RAP
C1.O1 Media Feed RAP
C2.01 Media Feed RAP
C3.01 Media
Feed RAP
C1
. O 5 Media Feed RAP
C2.05 Media Feed RAP
C3.05Media Feed RAP
C3.06
Media Feed
RAP
NOTE 1 : Substitute either 1 , 2 , or
3 for X depending on which status code is displayed.
NOTE 2 : For roll feed problems that are not indkated by a status code and the message display reads, Refeed Roll 1,2,0r 3 , proceed to the RAP that
matches the message display.
NOTE 3 :
For media feed problems that are not indicated by a status code and the message display reads, Please Open The Cut Sheet Feed-ln Shelf,
proceed to the O F 3 Media Does Not Feed Rap
3193
Status Code Entry Chart
1-6 3050