Xerox 3050 Service Manual page 506

I
REP 10.9 Oil Pads
I
Parts List on PL 10.5
I
Removal
I
I .
Warning: Disconnect the power cord.
1
2.
Lower the Front Latching Cover.
I
3. Remove the following:
a. Stripper Finger Assembly
(REP
10.6)
b. Oil Dispense Assembly (REP 10.7)
(
4. (Figure 1): Remove the Oil Pads.
I
Replacement
To avoid damaging the oil dispense
roll, do not pull the wick too tight
over the extrusion.
STEP 1 A: To avoid folding the wick or
pulling the wick too tight, use the oil
pad covers as guides when installing
the oil pads.
I
1.
(Figure 2): Install
the
Oil
Pads,
I
2. Reinstall the Oil Pad Covers.
(Continued)
REMOVE THE OIL PADS (2)
REMOVE THE OIL PAD COVERS (2)
Figure 1 . Removing the Oil Pads
01814
INSTALL OIL PAD REPEAT
INSTALL OIL PAD COVERS (2)
Y
. -.
.
.
THE STEPS A AND B TO
INSTALL THE SECOND'OIL PAD
Figure 2. Installing the Oil Pads
REP 10.9