Xerox 3050 Service Manual page 524

(Continued)
a
Each increment on the display equals
4. Press the Start button i n order to enter the
1/32 inch (0.8
mm)
of change on the
new value into NVM.
3. (Figure 2): Check the length difference COPY*
between the test pattern and the copy.
5. Exit the diagnostic mode.
Adjustment
1. Enter the diagnostic mode.
3.
Use the Copy contrast up arrow button i n
order t o increase the length of the copy
6.
Repeat the CheckfAdjust until the copy i s
media, or the Copy contrast down arrow
within
+
118 inch
(
23.0 mm) of the
test
button i n order to decrease the length of
pattern.
the
copy media.
2. Enter the code 108621 i n order to adjust the
A
time at which the Cutter Drive Motor is
AUGN THE EDGE OF THE TEST
energized.
f
PATTERN WITH THE EDGE OF THE
FOLDED COPY
TEST PATTERN
FOLDED COPY
B
MEASURE THE LENGTH DIFFERENCE
BETWEEN THE FOLDED COPY AND THE TEST
PATTERN TO WITHIN f 1/8 INCH (
f
3.0 mm)
Figure
2.
Measure the Length Difference Between the Test Pattern and the Copy
ADJ 8.2