Xerox 3050 Service Manual page 454

I
REP 9.3A Photoreceptor Drum
(WI 0 Tag1 MOD 27)
Parts List on PL 9.2
I
Note: Some copien are equipped with
a
Wing Nut located on the end o f the Drum
Shaft. The Wing Nut is identified as Tagl
MOD
27,
Copiers without8 Wing Nut are
identified as (W I 0 Tag 1 MOD 27).
/
aemrnrrc rur
Use this procedure on copien without a
2. Remove the Right
and the Left Side
W h g Nut, (W I0 Tag1 MOD 27). Doors.
Copiers equipped with a Wing Nut are 3. Remove the Xerographic Module
(REP
identified as With Tag I MOD 27, (W I Tag
1
9.1).
MOD 27).
4.
Remove the Photoreceptor Drum
Removal
Assembly (REP 9.2).
1. Warning: Disconnect the Power Cord.
5. (Figure 1): Remove the Photoreceptor
Drum.
REMOVE
Figure 1. Remove the Photoreceptor Shaft Assembly
(Continued)
4196
REP 9.3 A
4-68 3050