Xerox 3050 Service Manual page 515

ABU 3.2 Country Configuration
Purpose
The purpose of this procedure is to set up the
correct input power, media width, and billing
meter configuration.
0
WIO
TsglMOD 6 :
50 Hz copiers
requiring 240VAC: DO NOTset the
code 102611 to 240 VAC. Set the code
fO26ll to220 VAC. When the code
lo2611
is
set to 240 VAC,
a
fusing
temperature run away may occur in
normal copy mode or when using the
codes[1004] and 1092
1 1 .
WI
raglMOD
6 :
50 Hz copiers
reguirlng
24OVAC:
The code (02611
may be set
to 240 VAC.
Adjust
1. Enter the diagnostic mode.
2. Enter the code I0261).
3. To adjust the Input power configuration,
use the Copy UP button
in
order t o
increase or the Copy DOWN button in
order to decrease the value that i s
displayed on the Control Console.
Adj Configuration
4.
Press the Start button t o enter the new
value.
5. Press the Stop button two times.
6. Enter the'code
102621.
7.
To adjust the media width configuration,
use the Copy
UP
button i n order to
increase or the Copy
DOWN
button i n
order to decrease the value displayed on
the Control Console.
Adj Conflguratlon
t inch
2 metric
3
both
8.
Press the Start button to enter
the
new
value.
9. Press the Stop button two times.
10.
Enter the code
[0263).
1 1. To adjust the
billing
meter configuratlon,
use the
Copy UP
button
in
order to
increase or the Copy DOWN button in
order to decrease the value displayed on
the Control Console.
Ad/ Conflguratlon
0
feet
1
metric
12.
Press the
Start
button to enter the new
value.
13. Exi
t
the diagnostic mode.
ADJ 3.1, ADJ 3.2