Xerox 3050 Service Manual page 329

CQ
12
localixed Deletions Probable Cause
1. Media is damp.
Corrective Action
la. Cut sheet media:
Make a copy, using a sheet of media from
a new pack of media.
If the problem is corrected, ensure that the
media is being stored correctly.
1 b. Roll media:
Remove and discard the first
3
to 6 feet (1
to 2 metres) of media from the roll. Make
a copy on the new media.
If the problem
is
corrected, ensure that the
roll media is being stored correctly.
Refer to Section
2
and ensure that the
Media heater is working.
2.
Fabric Guide
i s
contaminated or wrinkled.
2.
Replace the Fabric Guide
(REP
8.9).
3. Fabric Guide not tensioned correctly. 3. Ensure that the Fabric Guide is installed
correctly.
Definition
4.
Corotrons are dirty, have loose wires or the
4.
Check for connector damage or loose
Deletions are areas on the copy where the
corotron connectors are not connected wires. Clean the corotron if
it
is dirty.
image is missing. (The causes for the defects correctly.
Repair or replace corotron if it i s damaged
are on the following two pages.)
and perform the Electrostatic Series
( ADJ
9.2).
(Continued)
CQ 12 Localized Deletions