Xerox 3050 Service Manual page 11

Refer to the Change TaglMOD Index
for information on how to determine
whether or not a copier has a particular
TaglMOD number.
FOR
EXAMPLE:
THERMISTOR (RTI) REPAIR PROCEDURE
WARNING
1. Switch off the copier and disconnect
the power cord.
WI
TaglMOD 5: Remove the
Xerographic Module.
In the step 1, the WI TagIMOD
5
statement
refers to the modification number
5.
If the
copier that is being serviced does have
TaglMOD 5, perform this step.
If the copier does not have TaglMOD number
5, ignore the WI TaglMOD 5 instruction. In this
situation, do not remove the xerographic
module.
2. Lower the transport latching cover.
3. Lower the front cover.
In the steps 2 and 3, no reference i s made to
either the with or without TagIMOD 5
modification. Therefore, perform the
instructions whether the copier has or does
not have TaglMOD 5.
lot92
3050
ix
Introduction