Contamination Seal - Xerox 3050 Service Manual

REP 9.1 5 Contamination Seal 3. (Figure 1): Remove the Contamination Seal.
Replacement
Parts List on PL 9.5
Removal
1. Warning: Disconnect the power cord.
4.
the Auger and the area 1. (Figure 2): Place the new Contamination
where the Contamination Seal will be
installed.
Seal in the Xerographic Module.
2.
Remove the following:
a. Right and Left Side Doors (REP
14.1)
b.
Xerographic Module (REP 9.1)
c.
Photoreceptor Drum (REP
9.3)
PHOTORECEPTOR
d. Cleaner Blade (REP
9.4)
e. Charge CorotronIErase Lamp
(REP 9.8)
STEP3 A: Do not remove the
Photoreceptor Seal.
A
Q
REMOVE THE
CONTAMINATION SEAL
Figure 1 . Remove the Cartridge Drive Plate
B
PLACE THE SEAL IN THE
MODULE AND AGAINST THE
FROM THE DAMAGED SEAL
Figure 2. Place the Contamination Seal in
the Module
(Continued)
3050 4-95
REP 9.14