Xerox 3050 Service Manual page 455

(Continued)
Replacement
Do not remove the light shield until
Step 2
when the photoreceptor is
ready to be installed in the
xerographic module.
0
STEP 1 A: Ensure that the top of the
drum box is up before opening the
box.
1 0: The endshields (2) must be
2. (Figure 3): Prepare the Drum for
raised in order to position the drum
installation.
shaft end plates fully against the drum.
Q
STEP 1 0: When installing the drum
shaft, be sure
to
tiahten the three
retaining screws &enly and with equal
pressure.
REMOVE LIGHT
A -
1.
(Figure 2): Install the Photoreceptor
Assembly Shaft
SHIELD
C
REFER TO SECTION 6,
PHOTORECEPTOR DRUM
MAINTENANCE AND PERFORM
THE PHOTORECEPTOR
CLEANING ENHANCEMENT
Flgure 3. Prepare the Drum for lnslelletlon
(Continued)
4/96
3050 4-69
REP 9.3 A