Xerox 3050 Service Manual page 546

(Continued)
2. (Figure 4): Remove the Stripper Finger
Assembly.
WSH
:#/I
TO THE LEFT
B
\
ROTATE THE STRIPPER
FINGER ASSEMBLY
REMOVE THE STRIPPER
FINGER ASSEMBLY WHILE
DOING THE STEPS B AND C
Figure 4. Remove the Stripper Finger Assembly
Enter the diagnostic mode.
Enter the code [I0041 in order to switch
the the Fuser Heat Rod on and increase the
Fuser temperature to the run temperature.
The Drum/ Developer and Fuser Drive
Motors are switched on when the Heat
Roll Temperature reaches the run
temperature.
he
temperature is then
displayed on the Control Panel.
(Continued)
ADJ 10.2