Xerox 3050 Service Manual page 24

STATUS
CODE
C4.01
C4.24
C4.34
c4.49
CAUSE
The Sheet Feed Sensor was actuated during
a copy when Cut Sheet was not selected.
--
The cut sheet does not reach the Sheet Feed
Sensor in time.
The Sheet Feed sensor deactuated too early
while making a copy. The operator may
have to remove the cut sheet media.
This i s a Firmware problem.
CLEARANCE
GO TO RAP I N
SECTION 2
Refer to the display on the control panel C4.01 Sheet Feed
and follow the clearance procedure.
I
RAP
-
-
- --
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
-
C4.24 Sheet Feed
RAP
C4.01 Sheet Feed
RAP
NOTE 1 :
Substitute either 1,2, or
3
for X depending on which Status Code is displayed.
Press power off
(0)
then power on
(1). Call
Hotline if problem persists.
Status Code Entry Chart
1-10 3050
None