Xerox 3050 Service Manual page 19

STATUS
CODE
GO TO RAP IN
SECTION 2
CAUSE CLEARANCE
The time interval was too long between the
deactuation of the Insert Sensor and the
deactuation of the Front Document Sensor.
Refer to the display on the control panel
and follow the clearance procedure.
A1.63 Document
Handler RAP
The Front Document Sensor deactuated
before the insert document sensor.
Refer to the display on the control panel
and follow the clearance procedure.
Al.64 Document
Handler RAP
Insert Document sensor deactuated too
early. Document was too short.
Cutter could not return to the home
position, or did not move off the home
position.
Refer to the display on the control panel
and follow the clearance procedure.
Refer to the display on the control panel
and follow the clearance procedure.
Al.65 Document
Handler RAP
LL.30 Cutter Fault
RAP
The Roll X Position Sensor did not actuate or
deactuate.
Refer to the display on the control panel
and follow the clearance procedure.
C1.O1 and C1.05
Media Feed RAP
C2.01 and C2.05
Media Feed RAP
C3.01 and C3.05
Media Feed RAP
Refer to Note 1
Media Registration Sensor did not actuate
or deactuate.
Refer to the display on the control panel
and follow the clearance procedure.
C1 .O4 Media Feed
RAP
C2.04 Media Feed
RAP
C3.04 Media Feed
RAP
Motion was not detected or the media
stopped moving before it was scheduled to
stop. Possibly caused by an out of Media
condition.
-
Refer to the display on the control panel
and follow the clearance procedure.
C1.05 Media Feed
RAP
C2.05 Media Feed
RAP
C3.05 Media Feed
RAP
Roll
3
media i s not detected at the Roll 2
Position Sensor.
C3.06 Media Feed
RAP
Refer to the display on the control panel
and
follow the clearance procedure.
NOTE 1 : Substitute either 1,2, or 3 forX depending on which Status Code is displayed.
NOTE 2: For roll feed problems that are not indicated by a status code and the message display reads, Refeed Roll l,%or 3 ,
proceed to the RAP that matches the message display.
NOTE 3: For media feed problems that are not indicated by a status code and the message display reads, Please Open The Cut
Sheet Feed-In Shelf, proceed to the OF3 Media Does Not Feed RAP
Status Code Entry Chart