Xerox 3050 Service Manual page 613

The copies made in the next step are not
Q
for copy quality. They are run to remove
any excess fuser oil from the fuser heat
roll.
20. Make 5 copies on 36 inch (914 mm) bond
media. Use the white side of test pattern
82E5980.
21.
Switch the copier off.
Use extreme caution in the next steps.
Use a thick cloth to wipe the excess oil
from the ends o f the fuser heat roll and
the fabric guide The Fuser Heat Roll and
the Fabric Guide will be very hot.
.
22. Lower the Media Feed-in Shelf.
23. Remove the Stripper Finger Assembly.
24. Wipe exdess oil from the ends of the Fuser
Heat Roll and the Fabric Guide.
25. Reinstall the Stripper Finger Assembly.
26. Wash your hands t o remove any fuser oil
that may remain on them.
27. Switch on the copier
28. Make 5 copies of test pattern 82E5980 and
check the copy quality.
8/94
3050 6-1 I
Initialization of the Fuser Roll