Xerox 3050 Service Manual page 487

REP 10.1A Fuser Heat
Rod
(W/ 0 Tag/ MOD 28)
Parts List on PL 10.2
NOTE: Some copien are eaui~ped with
Motor (MOT22).
4. Remove the Right and Left Side Door ( R E P
Copiers equipped with TWO AC Drive Motors
4.
,,
are identified
as Without Tag I MOD 28,
-
(W I 0 Tag / MOD 28).
5. Remove the Oil Dispense Assembly ( R E P
Other copien are equipped with ONE AC
10.7)
Drive Motor, Main Drive Motor (MOT21).
Copiers equipped with ONE AC Drive ~ o t o r
are identified as With Tag
1
MOD
28t
tW
I
(,
Remove the Xerographic Module (REP
Tag / MOD 28).
Use this procedure on copiers equipped with
9.1).
. - .
7W0 ~ c ~ r i v e Motors,
(w/
0 Tag /
MOD28).
, .
(Figure
On copiers equipped with ONE AC Drive
Rod.
Motor, refer to the (REP 10.18 Fuser Neat
Rod (W/Tag/MOD 28) removal procedure.
Removal
WARNINGS
Switch off the Main Power Switch
/!
\
and disconnect the Power Cord.
The Fuser Heat Roll may be HOT ! To
prevent burns, allow the Roll to cool
before removing the Xerographic
Module.
1): Prepare to Remove the Heat
Figure
1. Prepare to Remove
the Heat
Rod
1. Ensure that the Heat Roll
i s cool.
2. Lift and rotate the Control Console.
4196
3050 4-97
REP 10.1A