Xerox 3050 Service Manual page 25

CAUSE CLEARANCE
GO TO RAP IN
I
SECTION 1
STATUS
CODE
I
I
The media trail edge jammed i n the Media
Registration Sensor area.
This
is
a Firmware problem.
-
-
-
-
-
- -
The media trail edge jammed in the Media
Exit Switch area.
Lead edge of media is jamed against a Heat Refer to the display on the control panel
E4.03 Media
Roll stripper finger.
I
and follow the clearance procedure.
I
Transportation RAP
Refer to the display on the control panel
and follow the clearance procedure.
Press power off (0) then power on (1). Call
Hotline i f problem persists.
Lead edge of media did not reach the Media
Exit Switch in time.
This is a Firmware problem.
E2.01 Media
Transportation RAP
None
Refer to the display on the control panel
and follow the clearance procedure.
E4.01 Media
Transportation RAP
Refer to the display on the control panel
and follow the clearance procedure.
Upper Rear Door i s open.
E4.02 Media
Transportation RAP
Press power off (0) then power on (1). Call
Hotline
if
problem persists.
Refer t o the display on the control panel E5.03 Upper Rear
and follow the clearance procedure.
I
Door Open RAP
None
Cutter is open.
Right Side Door is open.
Sheet Feed Shelf is open.
I
Refer to the display on the control panel E5.06 Right Side
and follow the clearance procedure.
I
Door Open RAP
Refer to the display on the control panel
and follow the clearance procedure.
E5.04Cutter Cover
Open RAP
Refer to the display on the control panel
and follow the clearance procedure.
E5.05 Sheet Feed
Shelf Open RAP
The Document Handler is out of position.
The Stop button was pressed, or the front
doors opened while a copy was being made
in the Roll Feed mode.
121 97
3050
1-11
Status Code Entry Chart
Reinstall the Document Handler
The Stop button was pressed, or the front
doors opened while a copy was being made
i n the Cut Sheet mode.
E5.07 Document
Handler Open RAP
Refer t o the display on the control panel
and follow the clearance procedure.
E6.00 Media Supply
Doors Open RAP
Refer t o the display on the control panel
and follow the clearance procedure.
E6.00 Media Supply
Doors Open RAP