Setup Of Parameter And Mode; Outline / Setup / Connection - Panasonic MINAS A6 Series Operating Instructions Manual

2
Preparation
Outline of Parameter
This driver is equipped with various parameters to set up its characteristics and functions.
This section describes the function and purpose of each parameter. Read and compre-
hend very well so that you can adjust this driver in optimum condition for your running
requirements.
Setup of Parameter
• You can refer and set up the parameter with either one of the following.
1) front panel of the driver
2) combination of the setup support software, "PANATERM" and PC.
Note
How to control the front panel, refer to P.2-74.
Setup with the PC
It is possible to connect your personal computer to connector X1 of MINAS A6 using a
USB cable for personal computer connection. Downloading the setup support software
"PANATERM" from our web site and installing it on your personal computer will allow you
to perform the following easily.
• With the PANATERM, you can execute the followings.
1) Setup and storage of parameters, and writing to the memory (EEPROM).
2) Monitoring of I/O, pulse input and load factor.
3) Display of the present alarm and reference of the error history.
4) Data measurement of the wave-form graphic and bringing of the stored data.
5) Normal auto-gain tuning
6) Frequency characteristic measurement of the machine system.
Note
Because no production software such as CD-ROM is available, download the setup sup-
port software from our web site and install it on your personal computer.
• How to Connect
• USB cable
On the driver, use commercially available USB mini-B connector.
The connector on the personal computer side should be in accordance with the specifi-
cations of the PC.
When the cable does not have noise filter, attach a signal line noise filter (DV0P1460)
to both ends of the cable.
Related page
• P.4-2 "Details of Parameter"
• P.7-26 "Setup support software [PANATERM]"
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
2-50

12. Setup of Parameter and Mode

Outline / Setup / Connection

Connect to X1
(USB mini-B)
Setup support software "PANATERM"
Please download from our web site and
use after install to the PC.