Panasonic MINAS A6 Series Operating Instructions Manual page 46

1. Conformance to international standards
Composition of Peripheral Equipments
Power Supply
100 V type:
(A to C-frame)
200 V type:
(A to D-frame)
200 V type:
(E to F-frame)
(1) This product is designed to be used in over-voltage category (installation category) III
of EN 61800-5-1:2007.
(2) Use an insulated power supply of DC12 to 24 V which has CE marking or complies
with EN60950.
• Use sheathed (jacketed) cable, twisted cable or closely bundled cable for power cable.
Remarks
• Power cable and signal wires must be sufficiently isolated from each other.
Twisted
Circuit Breaker
Install a circuit breaker which complies with IEC Standards and UL recognized (Listed
and
The short-circuit protection circuit on the product is not for protection of branch circuit.
The branch circuit should be protected in accordance with NEC and the applicable local
regulations in your area.
Note
For driver and applicable peripheral equipments, refer to P.2-10 "Driver and List of Applicable
Peripheral Equipments".
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
2-6
Single phase, 100 V
Single/3-phase, 200 V
Servo dr ver
L1C
L2C
marked) between power supply and noise filter.
+10 %
to 120 V
–15 %
+10 %
to 240 V
–15 %
+10 %
3-phase, 200 V to 240 V
–15 %
Closely bundled cable
United
+10 %
50 Hz/60 Hz
–15 %
+10 %
50 Hz/60 Hz
–15 %
+10 %
50 Hz/60 Hz
–15 %
Servo dr ver
L1
L2
L3