Monitor Mode (Execution Display) - Panasonic MINAS A6 Series Operating Instructions Manual

Ac servo motor & driver

Hide thumbs Also See for MINAS A6 Series:

Table of Contents

14. How to Use the Front Panel

Monitor Mode (EXECUTION display)

(5) Display of I/O Signal Status

Displays the control input and output signal to be connected to connector X4.

Use this function to check if the wiring is correct or not.

• Shift the flashing decimal point with

• Select In or Out by pressing

• Select the Pin No. to be monitored by pressing

*1 When input signal

When output signal Active : Output signal transistor is ON.

For detail of input/output signal, refer to P.3-33 "Inputs and outputs on connector X4"

For detail of Error Code, refer to P.6-2 "Protective Function".

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com

.....Inactive

.....Input signal

.....Output signal

(Right side of decimal point : Pin No. selection)

(Left side of decimal point : Input/Output Pin No. selection)

Active : Input signal photocoupler is ON.

Inactive : Input signal photocoupler is OFF.

Inactive : Output signal transistor is OFF.

(Lowest place Pin No.

of output signal)

(Highest place Pin No.

of input signal)

Table of Contents