Terminal X46/5 Digital Input; Terminal X46/7 Digital Input - Danfoss VLT AutomationDrive FC 302 Programming Manual

Parameter Descriptions
5-21 Terminal X46/3 Digital Input
Option:
[94] Light Load Detection
[96] Mains Loss
[97] Mains Loss Inverse
[98] Start edge triggered
[100] Safe Option Reset
[107] Target Inverse
[108] Enable Master Offset
[109] Start Virtual Master
[110] Start Homing
[111] Activate Touch
[112] Relative Position
[113] Enable Reference
[114] Sync. to Pos. Mode
[115] Home Sensor
[116] Home Sensor Inv.
[117] Touch Sensor
[118] Touch Sensor Inv.
[119] Speed Mode
[231] Power Limit Mot.
[232] Power Limit Gen.
[233] Power Limit Both

5-22 Terminal X46/5 Digital Input

Option:
[0] No operation
*
[1] Reset
[2] Coast inverse
[3] Coast and reset inv
[4] Quick stop inverse
[5] DC-brake inverse
[6] Stop inverse
[8] Start
[9] Latched start
[10] Reversing
[11] Start reversing
[12] Enable start forward
[13] Enable start reverse
[14] Jog
[15] Preset reference on
[16] Preset ref bit 0
[17] Preset ref bit 1
[18] Preset ref bit 2
[19] Freeze reference
[20] Freeze output
[21] Speed up
[22] Speed down
MG33MP02
Programming Guide
Function:
Function:
This parameter is active when
®
option module VLT Extended
Relay Card MCB 113 is installed in
the frequency converter.
Functions are described in
parameter group 5-1* Digital
Inputs.
Danfoss A/S © 10/2018 All rights reserved.
5-22 Terminal X46/5 Digital Input
Option: Function:
[23] Set-up select bit 0
[24] Set-up select bit 1
[28] Catch up
[29] Slow down
[34] Ramp bit 0
[35] Ramp bit 1
[44] Restart Drive
[51] External Interlock
[55] DigiPot increase
[56] DigiPot decrease
[57] DigiPot clear
[58] DigiPot Hoist
[62] Reset Counter A
[65] Reset Counter B
[70] Mech. Brake Feedb.
[71] Mech. Brake Feedb. Inv.
[72] PID error inverse
[73] PID reset I part
[74] PID enable
[75] MCO Specific
[78] Reset Maint. Word
[80] PTC Card 1
[91] Profidrive OFF2
[92] Profidrive OFF3
[94] Light Load Detection
[96] Mains Loss
[97] Mains Loss Inverse
[98] Start edge triggered
[100] Safe Option Reset
[107] Target Inverse
[108] Enable Master Offset
[109] Start Virtual Master
[110] Start Homing
[111] Activate Touch
[112] Relative Position
[113] Enable Reference
[114] Sync. to Pos. Mode
[115] Home Sensor
[116] Home Sensor Inv.
[117] Touch Sensor
[118] Touch Sensor Inv.
[119] Speed Mode
[231] Power Limit Mot.
[232] Power Limit Gen.
[233] Power Limit Both

5-23 Terminal X46/7 Digital Input

Option: Function:
[0] No operation This parameter is active when
*
option module VLT
Relay Card MCB 113 is installed in
the frequency converter.
3 3
®
Extended
113