6
. CYLINDER HEAD/VALVES
DINK 200i/125
CAMSHAFT
REMOVAL
Turn the A.C. generator flywheel so that the
Tensioner Sealing Bolt/Spring
"T" mark on the flywheel aligns with the
index mark on the crankcase.
Hold the round hole on the camshaft gear
facing up and the location is the top dead
center on the compression stroke.
Remove the tensioner sealing bolt and spring.
Remove the two bolts from cam chain
tensioner and then remove the tensioner and
gasket.
Round Hole
Remove the camshaft holder (refer to the
"CAMSHAFT HOLDER" section in this
chapter).
Cam Chain
Remove the camshaft from the cam chain.
Camshaft Gear
6-8