KYMCO DINK 200i Service Manual page 50

1. GENERAL INFORMATION
CLUTCH, DRIVE AND DRIVEN PULLEYS
Engine starts but motor-
cycle does not move
Motorcycle creeps or
engine starts but soon
stops or seems to rush
out (Rear wheel rotates
when engine idles)
Engine lacks power at
start of a grade(poor
slope performance)
Engine lacks power at
high speed
There is abnormal noise
or smell while running
1-47
Symptom
Probable Cause
cWorn or slipping drive belt
dBroken ramp plate
eBroken drive face spring
fSeparated clutch lining
gDamaged driven pulley shaft splines
hDamaged final gear
iSeized final gear
cBroken shoe spring
dClutch outer and clutch weight stuck
eSeized pivot
cWorn or slipping drive belt
dWorn weight rollers
eSeized drive pulley bearings
fWeak driven face spring
gWorn or seized driven pulley bearings
cWorn or slipping drive belt
dWorn weight rollers
eWorn or seized driven pulley bearings
cOil or grease fouled drive belt
dWorn drive belt
eWeak driven face spring
fWorn or seized driven pulley bearings
DINK200i/125