Camshaft Holder - KYMCO DINK 200i Service Manual

6
. CYLINDER HEAD/VALVES

CAMSHAFT HOLDER

REMOVAL
Remove the four cap nuts/washers from
camshaft holder.
x Diagonally loosen the cylinder head
cap nuts in 2 or 3 times.
Remove the camshaft holder and two dowel
pins.
INSTALLATION
Install the camshaft holder, washers and nuts.
Tighten the four cylinder head nuts to the
specified torque.
Torque:
DINK 200i: 2.3 kgf-m (23 N-m, 16.6 lbf-ft)
DINK 125: 2 kgf-m (20 N-m, 14.4 lbf-ft)
x Install the camshaft holder with the
"EX" mark face exhaust valve side.
x Apply engine oil to the threads of the
cylinder head cap nuts.
x Diagonally tighten the cylinder head
cap nuts in 2 3 times.
Adjust:
valve clearance (refer to the "VALVE
CLEARANCE" section in the chapter 3).
6-5
DINK 200i/125
Camshaft Holder/Dowel Pins