KYMCO DINK 200i Service Manual page 39

1. GENERAL INFORMATION
CLUTCH, DRIVE AND DRIVEN PULLEYS
Engine starts but motor-
cycle does not move
Motorcycle creeps or
engine starts but soon
stops or seems to rush
out (Rear wheel rotates
when engine idles)
Engine lacks power at
start of a grade(poor
slope performance)
Engine lacks power at
high speed
There is abnormal noise
or smell while running
Symptom
Probable Cause
c Worn or slipping drive belt
d Broken ramp plate
e Broken drive face spring
f Separated clutch lining
g Damaged driven pulley shaft splines
h Damaged final gear
i Seiaed final gear
c Broken shoe spring
d Clutch outer and clutch weight stuck
e Seized pivot
c Worn or slipping drive belt
d Worn weight rollers
e Seized drive pulley bearings
f Weak driven face spring
g Worn or seized driven pulley bearings
c Worn or slipping drive belt
d Worn weight rollers
e Worn or seized driven pulley bearings
c Oil or grease fouled drive belt
d Worn drive belt
e Weak driven face spring
f Worn or seized driven pulley bearings
DINK 200i/125
1-36