KYMCO DINK 200i Service Manual page 318

15.HANDLEBAR/FRONT WHEEL/FRONT BRAKE/
FRONT SHOCK ABSORBER/STEERING STEM
Rest the brake hose eyelet against the stopper.
Install the brake hose eyelet with the oil bolt
and new sealing washers.
Tighten the oil bolt to the specified torque.
Torque: 35 N•m (3.5 kgf•m, 25 lbf•ft)
Apply silicone grease to the master piston tip.
Install the brake lever.
Apply silicone grease to the brake lever pivot
bolt sliding surface.
Install and tighten the pivot bolt to the
specified torque.
Torque: 2 N•m (0.2 kgf•m, 1.4 lbf•ft)
Install and tighten the pivot nut to the
specified torque.
Torque: 10 N•m (1 kgf•m, 7.2 lbf•ft)
Connect the brake light switch connectors.
Fill the reservoir to the upper level and bleed
the brake system (refer to the "FRONT
BRAKE FLUID" section in this chapter).
15-21
DINK 200i125