KYMCO DINK 200i Service Manual page 258

14. DINK 200 i:
Failure
Blinks
Codes
21 P0105 Manifold pressure fault
22 P1110 Angle detect sensor fault
23 P0136 O2 sensor circuit malfunction
24 P0141
25 P0171 Close loop fault
FUEL SYSTEM (Auto Control Fuel Injection System)
Fault description
O2 heater/O2 sensor circuit
malfunction
Priority Fault management
1.Confirm whether the output voltage
of the sensor is within
specification?
2.Check whether the output pin
position of the sensor is correct or
open circuit occurs? (the ECU pin
2
8)
3.Replace with a new sensor
according to the part-exchanging
process to confirm whether the
error code still exists?
1.Confirming the sensor know the
machine outputs electric voltage
whether in the specification?
2.Does confirming the sensor know
the machine deals with contact,
connects line and hasn't moved
2
and break road? (the ECU pin 11)
3.If still appear an abnormality,
change to turn to pour sensor to
know lately the machine confirms
whether does the sensor know a
machine abnormality?
1.Check the connector or pin.
1
2.Replace with a new part.
2
Does not have the information.
Close loop correction value out of
1
the range, check the engine CO%.
14-16