KYMCO DINK 200i Service Manual page 386

20. LIGHTS/METERS/SWITCHES
HEADLIGHT
• •
A halogen headlight bulb becomes very
hot while the headlight is ON, and
remain for a while after it is turned OFF.
Be sure to let it cool down before
servicing.
Remove the front cover (refer to the
"FRAME COVERS
REMOVAL/INSTALLATION" section in
the chapter 2).
Disconnect the headlight connector (1) from
the headlight bulb and remove the dust cover
(2).
Unhook the retainer (3) and remove the bulb
(4) from the headlight case.
• •
Avoid touching the halogen headlight
bulb. Finger prints can create hot spots
that cause a bulb to break.
Install a new bulb in the headlight case, by
aligning the bulb tab with the case groove.
Hook the retainer.
Install the dust cover properly on to the
headlight and connect the headlight connector
20-3
DINK 200i/125